Square Scrub EBG-28 ECCENTRIC REPLACEMENT KIT - SS 142802SEAL

• Complete eccentric assembly restoration kit: The Square Scrub EBG-28 Eccentric Replacement Kit (SS 142802SEAL) includes the essential components needed to replace the eccentric assembly and restore reliable orbital performance.
• Improves machine performance and consistency: Replacing worn eccentric components helps maintain smooth operation for sanding, stripping, scrubbing, and floor preparation applications.
• Includes critical repair components: The kit comes with 8 isolators, isolator bolts, motor shaft spacer, shaft cap bolt, bearing bolts, eccentric assembly, crush washer, eccentric key, grip face, anti-seize, and silicone sealant.
• Designed for EBG-28 machines: This OEM replacement kit is made for Square Scrub 28" machines with serial numbers beginning with 32U, helping ensure proper fit and compatibility.
• Expert tip: Replace isolators during eccentric repairs to help maintain stability, reduce vibration, and maximize the service life of the machine.

Q: What is the Square Scrub EBG-28 Eccentric Replacement Kit SS 142802SEAL?
A: It is a complete replacement kit designed to rebuild the eccentric assembly on Square Scrub EBG-28 floor machines, helping restore proper orbital motion and floor preparation performance.

Q: Which machines are compatible with SS 142802SEAL?
A: This kit is compatible with Square Scrub EBG-28 machines with serial numbers beginning with 32U. It is not the PIVOT version.

Q: What components are included in the eccentric replacement kit?
A: The kit includes 8 isolators, isolator bolts, motor shaft spacer, motor shaft cap bolt, bearing bolts, eccentric assembly, eccentric assembly key, crush washer, grip face, anti-seize, and 100% silicone.

Q: When should the EBG-28 eccentric kit be replaced?
A: It is recommended when the eccentric assembly shows wear, reduced machine performance, or requires rebuilding to maintain consistent sanding and surface preparation results.

Q: Should isolators be replaced when installing this kit?
A: Yes. Square Scrub recommends installing new isolators during eccentric assembly replacement for optimal performance and reliability.

Q: Is SS 142802SEAL the same as the EBG-28 PIVOT repair kit?
A: No. SS 142802SEAL is for standard EBG-28 machines with 32U serial numbers, while the EBG-28 PIVOT version uses part number SS 142802 PVT.

Q: What is the part number for this product?
A: The manufacturer part number is SS 142802SEAL.

• Inspect the eccentric assembly regularly for unusual vibration, noise, or reduced machine performance.
• Check isolators, bolts, bearings, and mounting hardware for wear or looseness during routine maintenance.
• Keep the eccentric area clean and free from dust, debris, and moisture to help protect internal components.
• Replace worn isolators when servicing the eccentric assembly to maintain proper balance and vibration control.
• Verify all hardware is properly secured after installation, including shaft bolts, bearing bolts, and eccentric components.
• Use recommended installation materials, including anti-seize and silicone sealant where specified, to support long-term reliability.
• Confirm the kit matches your EBG-28 machine requirements; this replacement kit is intended for 28" machines with serial numbers beginning with 32U.
• Follow Square Scrub repair procedures and inspect the grip face condition during eccentric assembly service.